Honey Well logo

Honey Well HT-800 High Velocity Circulator User Manual

Honey Well HT-800 High Velocity Circulator

IMPORTANT SAFETY INSTRUCTIONS

READ AND SAVE THESE SAFETY INSTRUCTIONS BEFORE USING THIS FAN
When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:

FOR US MODELS ONLY – This product employs overload protection (fuse). A blown fuse indicates an overload or short circuit situation. If the fuse blows, unplug the product from the outlet. Replace the fuse as per the user servicing instructions(follow product marking for proper fuse rating) and check the product. If the replacement fuse blows, a short-circuit may be present and the product should be discarded or returned to an authorized service facility for examination and/or repair.

  1. Use this fan only as described in this manual. Other use not recommended, may cause fire, electric shock or injury to persons.
  2. This product is intended for household use ONLY and not for commercial, industrial or outdoor use.
  3.  To protect against electric shock, do not place fan in window, immerse unit, plug or cord in water or spray with liquids.
  4.  This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of shock, this plug is intended to fit only one way in a polarized outlet. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician.
    DO NOT attempt to defeat this safety feature.
  5.  Close supervision is necessary when any appliance is used by or near children.

WARNING: To Reduce The Risk of Fire or Electric Shock, Do Not Use This Fan With Any Solid State Speed Control Device.

FUSED SAFETY PLUG

FOR US MODELS ONLY

This fan features a fused safety plug which is designed to cut off electric current to the fan if an electrical fault occurs. Please see below for more information on how to properly use your fan and replace the safety plug fuse, if needed.

USER SERVICING INSTRUCTIONS

Honey Well HT-800 High Velocity Circulator fig 1

 

  1.  Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on cord.
  2. If your fan loses power and you suspect that the fuse on your fan has blown, you should first remove the spare fuse holder attached to the ord plug (Fig. 1). Remove the spare fuse from the plastic spare fuse
    holder, and set the spare fuse aside (Fig. 2).
  3.  You can gain access to the blown fuse by sliding open the door found on the side of the plug. Slide the door outward until the blown fuse is fully visible (Fig. 3).
  4. Remove the blown fuse and snap the replacement fuse into place. Risk of fire. Replace fuse only with 2.5 Amp, 125 volt fuse (provided with product). Fully close the fuse door by sliding back into place. Discard
    the blown fuse. The plug should now be ready for normal use
  5.  Risk of fire. Do not replace attachment plug. Contains a safety device (fuse) that should not be removed. Discard product if the attached plug s damaged.
  6.  If you need further information on how or when to replace the fuse in the safety plug, please contact Kaz Consumer Relations Department by visiting our website at www.HoneywellFanSavings.com or calling 1-800-477-0457.

INTRODUCTION

Honey Well HT-800 High Velocity Circulator fig 2

The Turbo Force® High Velocity Air Circulator Fans are aerodynamically designed to give you the versatility of changing this fan’s angular direction simply by adjusting the fan to the desired angular output (Fig.1). Upon using
this fan, you will feel a strong and powerful air stream that will quickly move air to provide a cooling effect.

Honeywell Air Circulator Fans can help save energy and can lower monthly utility bills all year round. Our air circulators increase distribution of cooler air from your air conditioner or warmer air from your heating system, creating a vortex of air flow for increased comfort. Increased air flow allows the air conditioning and heating systems to be used at lower settings to help save you money.

Honey Well HT-800 High Velocity Circulator fig 3

In the summer:
Circulate cool air by using with window or central air conditioning. Circulate cool air upstairs.

In the winter:
Circulate warm air. Position your air circulator in an open location for upward air movement. Run it on a low
setting to move the hotter air from the ceiling and circulate the warmer air throughout the room.

Increase Heating Source Efficiency:
Use with other heat sources, such as wood stoves, baseboard heaters, and or vents to help circulate the warm air throughout the room.

OPERATION

Honey Well HT-800 High Velocity Circulator fig 4

  • Be sure the fan is in the OFF position.
  • Place your fan on a dry, level surface.
  •  Plug the power cord into a polarized 120 volt AC wall outlet.
  •  To operate, turn the control knob to the desired fan speed:
    HIGH (III), MEDIUM (II) or LOW (I) (Fig. 2).
  •  For wide area oscillation, push down on the oscillation knob. To stop it, pull up on the knob. (Fig. 2)
  • Adjust the fan to the desired angular air output direction.
  •  To move the fan, turn the fan OFF and pick it up by the concealed handle that is located on the outside rim of the fan (Fig. 3).

CLEANING AND STORAGE

  •  Turn the fan off and unplug it before cleaning.
  •  Use only a soft cloth or cotton swab to gently wipe the fan clean.
  • To clean between the grilles, we recommend using a pipe cleaner, vacuum cleaner, flexible dust wand or compressed air to gently remove the dust.
  • DO NOT immerse the fan in water and never allow water to drip into the motor housing.
  • DO NOT use gasoline, paint thinner or other chemicals to clean the fan.

CONSUMER RELATIONS

Mail questions or comments to: Kaz USA, Inc. Consumer Relations Dept. 250 Turnpike Road Southborough, MA 01772 Call us toll-free at: 1-800-477-0457 E-mail: [email protected] Or visit our website at:
www.HoneywellFanSavings.com Please be sure to specify a model number.

NOTE: IF YOU EXPERIENCE A PROBLEM, PLEASE CONTACT CONSUMER RELATIONS FIRST OR SEE WARRANTY. DO NOT RETURN TO THE ORIGINAL PLACE OF PURCHASE. DO NOT ATTEMPT TO OPEN THE MOTOR HOUSING YOURSELF, DOING SO MAY VOID YOUR WARRANTY AND CAUSE DAMAGE TO THE FAN OR PERSONAL INJURY.

1 YEAR LIMITED WARRANTY

You should first read all instructions before attempting to use this product.

  • A. This 1 year limited warranty applies to repair or replacement of product found to be defective in material or workmanship. This warranty does not apply to damage resulting from commercial, abusive, unreasonable use or supplemental damage.
  • B.Ths. warranty does not cover damage resulting from any unauthorized attempts to repair or from any use not in accordance with the instruction manual
  • C. Return defective product to Kaz USA, Inc. with a brief description of the problem. Include proof of purchase and a $10 US/$15.50 CAN check or money order for handling, return packing and shipping charges. Please include your name, address and a daytime phone number.

DOWNLOAD LINK

https://www.honeywellstore.com/store/images/pdf/hf-910-honeywell-turboforce-floor-fan.pdf

Leave a comment

Your email address will not be published. Required fields are marked *